Setting The Mld Proxy Baseline - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

NOTE: Issue this command only on the upstream interface. Otherwise, this command
has no effect.
ipv6 mld-proxy version

Setting the MLD Proxy Baseline

You can set the counters for the numbers of queries received and reports sent on
the upstream interface to zero. This feature allows you to establish a reference point
for MLD proxy statistics.
baseline ipv6 mld-proxy interface
NOTE: Issue this command only on the upstream interface. Otherwise, this command
will have no effect.
Use to specify, in tenths of a second, how often the upstream interface should
transmit unsolicited reports.
Example
host1(config-if)#ipv6 mld-proxy unsolicited-report-interval 600
Use the no version to transmit unsolicited reports using the default value,
100-tenths of a second (10 seconds).
See ipv6 mld-proxy unsolicited-report-interval
Use to set the MLD proxy version for the interface.
Example
host1(config-if)#ipv6 mld-proxy version 1
Use the no version to set the version to its default value, MLDv2.
See ipv6 mld-proxy version.
Use to set the counters for the numbers of queries received and reports sent on
the upstream interface to zero.
Example
(host1)#baseline ipv6 mld-proxy interface
There is no no version.
See baseline ipv6 mld-proxy interface.
Chapter 6: Configuring Multicast Listener Discovery

Setting the MLD Proxy Baseline

211