Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 125

host1(config-profile)#exit
Configure a dynamic interface profile to specify the IP interface or MDT interface
2.
in the parent.
host1(config-profile)#profile pe1DataMdtMdt
host1(config-profile)#ip virtual-router pe1
host1(config-profile)#ip unnumbered loopback 0
host1(config-profile)#ip pim sparse-mode
host1(config-profile)#exit
Configure the destination profile for dynamic IP tunnel creation.
3.
host1(config)#gre destination profile pe13DataMdtProfile virtual-router pe1
host1(config-dest-profile)#tunnel source 1.1.1.1
host1(config-dest-profile)#tunnel destination ip subnet 233.3.0.0/16
host1(config-dest-profile)#tunnel mdt profile pe1DataMdtMdt
host1(config-dest-profile)#profile pe13DataMdtMti
host1(config-dest-profile)#exit
The router uses this destination profile to verify whether it can create a dynamic
tunnel, and to supply additional configuration parameters when it creates a
tunnel. For more information about creating dynamic IP tunnels, see Configuring
Dynamic IP Tunnels in the JUNOSe IP Services Configuration Guide.
Configure the group address pools in the route map.
4.
host1(config)#virtual-router pe1
host1:pe1(config)#ip pim group-address-pool pe13DataMdtGroups 233.3.1.0
233.3.1.255
If the data MDTs are established using ASM, you must divide the range of available
MDT P-Group addresses so that PEs source VPN multicasts. All VRFs in a PE draw
from a single address pool that contains the range of group addresses assigned
to that PE.
If the data MDTs are established using SSM, you can configure VRFs to transmit
on a tunnel using the same MDT P-Group address. Each VRF transmits using a
unique P-Source address; however, each data MDT created by the VRF must use
a different P-Group address. There might be one sender data MDT and possibly
many receiver data MDTs sharing an IP tunnel.
For SSM, each PE can assign MDT P-Groups from the same range, but the P-Group
addresses must be administratively divided among the VPNs as mentioned in
the following example:
host1(config)#virtual-router pe1
host1:pe1(config)#ip pim group-address-pool pe11DataMdtSSMGroups 233.3.1.0
233.3.1.255
host1:pe1(config)#ip pim group-address-pool pe12DataMdtSSMGroups 233.3.2.0
233.3.2.255
host1:pe1(config)#ip pim group-address-pool pe13DataMdtSSMGroups 233.3.3.0
233.3.3.255
Configure the access list to match <S,G> and <*,G> entries.
5.
host1:pe1(config)#virtual-router pe1:pe13
Chapter 3: Configuring PIM for IPv4 Multicast
Creating Multicast VPNs
103