Monitoring Mld - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

ipv6 router mld

Monitoring MLD

You can establish a reference point for MLD statistics by setting the statistics counters
to zero.
To display MLD parameters, use the show commands described in this section.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline ipv6 mld
show ipv6 mld
Use to create and enable MLD on a VR or to access MLD Router Configuration
mode.
Example 1
host1(config)#virtual-router boston
host1:boston(config)#router mld
Example 2
host1(config)#virtual-router boston
host1:boston(config)#ipv6 router mld
Use the no version to delete MLD and MLD proxy from the VR.
See router mld.
See ipv6 router mld.
Use to set the counters for MLD statistics to zero.
Example
(host1)#baseline ipv6 mld
There is no no version.
See baseline ipv6 mld.
Use to display MLD information for a VR.
Field descriptions
Administrative state Status of MLD in the software: enabled or disabled
Operational state Status of MLD on the VR: enabled or disabled
Chapter 6: Configuring Multicast Listener Discovery

Monitoring MLD

199