Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 87

Operational state Physical status of the interface: enabled or disabled
Version IGMP version
State Function of the interface: querier or nonquerier
Query Interval Time interval in seconds at which this interface sends query
messages
Other querier present interval Time in seconds that the interface waits
before declaring itself as the querier
Maximum response time Time interval, in tenths of a second, during which
this interface waits for a host to respond
Last member query interval Time, in tenths of a second, that this interface
waits before sending a new query to a host that sends a group leave message
Robustness Number of times this interface sends IGMP messages
Information about whether the interface accepts IGMP reports from hosts
on any subnetwork
Interface defaults to global promiscuous mode Interface uses the setting
of the igmp promiscuous command to determine whether it accepts
IGMP reports from hosts on any subnetwork
Information about standard IP access lists configured with the ip igmp
access-group command
Inbound access group Access list specified
No inbound access group No access list specified
Information about IP access lists configured with the ip igmp
access-source-group command
Inbound access source-group Access list specified
No inbound access source-group No access list specified
Information about OIF maps configured with the ip igmp apply-oif-map
command
Inbound apply-oif-map Map name specified
No inbound apply-oif-map No map name specified
Immediate Leave Setting of the ip igmp immediate-leave command:
enabled or disabled
Explicit Host Tracking Setting of the ip igmp explicit-tracking command:
enabled or disabled
Max-Group limit Number of IGMP groups that the interface can accept, as
configured with the ip igmp group limit command
Admission-Bandwidth limit Value of the admission-bandwidth limit set for
an interface that accepts IGMP groups, or No Limit
Chapter 2: Configuring IGMP
65
Monitoring IGMP