Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 53

QoS bandwidth QoS bandwidth per mroute, in bps
Uptime Length of time that the (S,G) pair has been active, in days
hours:minutes:seconds format
Data Rate Flow rate for the threshold entry, in Kbps
SPT Threshold SPT threshold value for the entry, in Kbps
Threshold Threshold value for the entry, in Kpbs
Expires Length of time that the (S,G) pair can be active, in days
hours:minutes:seconds format or never
RPF route IP address and subnetwork mask of the RPF route
incoming interface Type and specifier of the incoming interface for the
RPF route
neighbor address IP address of the neighbor
State/Owner Owner of the route
Local Route belonging to the local interface
Static Static route
Other protocols Route established by a protocol such as RIP or OSPF
Incoming interface list List of incoming interfaces on the router. Details
include:
Type of interface and its specifier
Action that the interface takes with packets: Accept or Discard
Multicast protocol that owns the interface
Outgoing interface list List of outgoing interfaces on the router. Details
include:
Type of interface and its specifier
Action that the interface takes with packets: Forward or Blocked
(port-limit)
Protocol running on the interface: PIM, DVMRP, or IGMP
Amount of time that the interface has been active in this multicast
forwarding entry, in days hours:minutes:seconds format
Length of time that the interface can remain active in this multicast
forwarding entry, in days hours:minutes:seconds format or never
Counts Number of types of source group mappings
(S, G) Number of (S, G) entries
(*, G) Number of (*, G) entries
Chapter 1: Configuring IPv4 Multicast
Monitoring IP Multicast Settings
31