Monitoring Mld Proxy - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.0.x Multicast Routing Configuration Guide

Monitoring MLD Proxy

To display MLD proxy parameters, use the following show commands.
show ipv6 mld-proxy
show ipv6 mld-proxy groups
212

Monitoring MLD Proxy

Use to display MLD proxy parameters for a VR.
Field descriptions
Routing Process MLD proxy protocol
Administrative state State of MLD proxy in the software
Operational state Operational state of MLD proxy: enabled or disabled
total interfaces Number of MLD proxy interfaces on the VR; currently only
one upstream interface per VR
state Operational state of the MLD proxy interfaces: enabled or disabled
multicast group Number of multicast groups associated with MLD proxy
interfaces
Example
host1#show ipv6 mld-proxy
Routing Process MLD Proxy, Administrative state enabled, Operational state
enabled
total 1 upstream interface, state enabled
1 multicast group
See show ipv6 mld-proxy.
Use to display information about multicast groups that MLD proxy reported.
Field descriptions
Grp Address Address of the multicast group
Interface Type and identifier of the upstream interface associated with the
multicast group
Grp Mode
Blank No sources included or excluded for this group
Include Sources included for this group
Exclude Sources excluded for this group
Count Total number of multicast groups associated with this interface
Example 1