Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual page 127

mdt-data-holddown
mdt-data-timeout
mdt-interval
set threshold
tunnel group-address-pool
Use the no version to return to the default.
See mdt-data-delay.
Use to configure the time in seconds before switching to the default MDT group
from the data MDT group.
The default is 60.
Example
host1(ip-pim-data-mdt-config)#mdt-data-holddown 200
Use the no version to return to the default.
See mdt-data-holddown.
Use to configure the time in seconds before the flow leaves the data MDT group.
The default is 180.
Example
host1(ip-pim-data-mdt-config)#mdt-data-timeout 160
Use the no version to return to the default.
See mdt-data-timeout.
Use to configure the time in seconds between successive MLD join TLV messages.
The default is 60.
Example
host1(ip-pim-data-mdt-config)#mdt-interval 80
Use the no version to return to the default.
See mdt-interval.
Use to configure a threshold value for multicast VPN applications, including
default MDT and data MDT.
Example
host1(config)#set threshold 30
Use the no version to remove the threshold.
See set threshold.
Chapter 3: Configuring PIM for IPv4 Multicast
Creating Multicast VPNs
105