Monitoring Igmp Proxy - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

Monitoring IGMP Proxy

To display IGMP proxy parameters, use the following show commands.
show ip igmp-proxy
show ip igmp-proxy groups
(host1)#baseline ip igmp-proxy interface
There is no no version.
See baseline ip igmp-proxy interface.
Use to display IGMP proxy parameters for a VR.
Field descriptions
Routing Process IGMP proxy protocol
Administrative state State of IGMP proxy in the software: enabled or
disabled
Operational state Operational state of IGMP proxy: enabled or disabled
total interface Number of IGMP proxy interfaces on the VR; currently only
one upstream interface per VR
state Operational state of the IGMP proxy interfaces: enabled or disabled
multicast group Number of multicast groups associated with IGMP proxy
interfaces
Example
host1#show ip igmp-proxy
Routing Process IGMP Proxy, Administrative state enabled, Operational
state enabled
total 1 upstream interface, state enabled
6 multicast group
See show ip igmp-proxy.
Use to display information about multicast groups that IGMP proxy reported.
Field descriptions
Grp Address Address of the multicast group
Interface Type and specifier of the upstream interface associated with the
multicast group
Member State State of the associated group address and interface
Idle Interface is going to send a group membership report to respond
to a group membership query for this group
Chapter 2: Configuring IGMP

Monitoring IGMP Proxy

75