Snmptrap Snmpversion; Snmptrap Ipaddr; Snmptrap Mode - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static

10.1.15 snmptrap snmpversion

This command modifies the SNMP version of a trap. The maximum length of
16 case-sensitive alphanumeric characters. The
snmpv2.
Note: This command does not support a "no" form.
Default
Format
Mode

10.1.16 snmptrap ipaddr

This command assigns an IP address to a specified community name. The maximum
length of name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make
Format
Mode

10.1.17 snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
Mode
10.1.17.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive.
Format
Mode
10-8
snmpv2
snmptrap snmpversion <name> <ipaddr> <snmpversion>
Global Config
multiple entries using the same IP address, the first entry is retained and
processed. All duplicate entries are ignored.
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Global Config
snmptrap mode <name> <ipaddr>
Global Config
no snmptrap mode <name> <ipaddr>
Global Config
v1.0, November 2007
can be snmpv1 or
<snmpversion>
is
<name>
SNMP Commands