Administrative Access Commands; Network Interface Commands; Enable - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

This section describes the management access and basic port configuration commands
available in the 7300S Series Stackable Switch CLI.
This section contains the following topics:
• Section 3.1 "Network Interface Commands" on page 3-1
• Section 3.3 "Console Port Access Commands" on page 3-7
• Section 3.4 "Telnet Commands" on page 3-10
• Section 3.5 "Secure Shell (SSH) Command" on page 3-15
• Section 3.6 "Hypertext Transfer Protocol (HTTP) Commands" on page 3-17
• Section 3.7 "User Account Commands" on page 3-24
The commands in this section are divided into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
To manage the device by using SNMP, see

3.1 Network Interface Commands

This section describes the commands you use to configure a logical interface for
management access.

3.1.1 enable

This command gives you access to the Privileged EXEC mode. From the Privileged
EXEC mode, you can configure the network interface.
Format
Mode

Administrative Access Commands

Administrative Access Commands
"SNMP Commands" in Chapter
enable
User EXEC
v3.0, January 2008
Chapter 3
10.
3-1