Boot Host Auto-Save; Boot Autoinstall Start; Boot Autoinstall Stop; Boot Host Retry-Count - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches

boot host auto-save

This command is used to enable automatically saving the downloaded configuration on the
switch.
Default Disabled
Format
boot host auto-save
Mode Privileged EXEC
no boot host auto-save
This command is used to disable automatically saving the downloaded configuration on the
switch.
Format
no boot host auto-save
Mode Privileged EXEC

boot autoinstall start

The command is used to start Auto Install on the switch. Auto Install tries to download a config
file from a TFTP server.
Format
boot autoinstall start
Mode Privileged EXEC

boot autoinstall stop

The command is used to A user might terminate the Auto Install process at any time prior to the
downloading of the config file. This is most optimally done when the switch is disconnected from
the network, or if the requisite configuration files have not been configured on TFTP servers.
Termination of the Auto Install process ends further periodic requests for a host-specific file.
Format
boot autoinstall stop
Mode Privileged EXEC

boot host retry-count

This command is used to set the number of attempts to download a configuration. The valid range
is from 1 to 6.
Default 3
Format
boot host retry-count <count>
Mode Privileged EXEC
Utility Commands
365