Information Center Configuration; Introduction To The Information Center Configuration Tasks; Configuring Synchronous Information Output - H3C S3100 8C SI Operation Manual

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches

1.2 Information Center Configuration

1.2.1 Introduction to the Information Center Configuration Tasks

Table 1-4 Information center configuration tasks

Configuring Synchronous Information Output

Configuring to Display the Time Stamp with the UTC Time Zone
Setting to Output System Information to the Console
Setting to Output System Information to a Monitor Terminal
Setting to Output System Information to a Log Host
Setting to Output System Information to the Trap Buffer
Setting to Output System Information to the Log Buffer
Setting to Output System Information to the SNMP NMS
1.2.2 Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the system information such
as log, trap, or debugging information is output when the user is inputting commands,
the command line prompt (in command editing mode a prompt, or a [Y/N] string in
interaction mode) and the input information are echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of
system output. With this feature enabled, the system echoes your previous input and
you can continue your operations from where you were stopped.
Table 1-5 Configure synchronous information output
Enter system view
Enable synchronous
information output
Operation
system-view
info-center
synchronous
Task
Command
1-8
Chapter 1 Information Center
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Description
—
Required
Disabled by default