Displaying And Maintaining System-Guard - H3C S3100 8C SI Operation Manual

Operation Manual – 802.1x-System Guard
H3C S3100 Series Ethernet Switches
Enable system-guard on
specified ports
Set the threshold for the
number of packets when
an attack is detected
Set the length of the
isolation after an attack is
detected

4.3 Displaying and Maintaining System-Guard

After the above configuration, execute the display command in any view to display the
running status of the system-guard feature, and to verify the configuration.
Table 4-2 Display and maintain system-guard
Display the record of detected attacks
Display the state of the system-guard
feature
Operation
system-guard permit
interface-list
system-guard
detect-threshold
threshold-value
system-guard
timer-interval
isolate-timer
Operation
Chapter 4 System-Guard Configuration (For S3100-EI)
Command
Required
By default, the system-guard
function is disabled on a port.
Optional
The default threshold value is
200 packets.
Optional
By default, the length of the
isolation after an attack is
detected is 10 minutes.
display system-guard attack-record
display system-guard state
4-2
Description
Command