Configuring Traffic Mirroring - H3C S3100 8C SI Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches
I. Configuration prerequisites
The burst function is required.
II. Configuration procedure
Table 1-33 Enable the burst function
Operation
Enter system view
Enable the burst
function
III. Configuration example
Enable the burst function.
Configuration procedure:
<Sysname> system-view
[Sysname] burst-mode enable

1.4.11 Configuring Traffic Mirroring

Note:
Only H3C S3100-EI series switches support this configuration.
Refer to section
I. Configuration prerequisites
The ACL rules for traffic classification are defined. Refer to the ACL module of this
manual for information about defining ACL rules.
The destination mirroring port is determined.
II. Configuration procedure
You can configure traffic mirroring on all the packets matching specific ACL rules, or on
packets that match specific ACL rules and are of a VLAN, of a port group, or pass a
port.
Command
system-view
burst-mode enable
Traffic Mirroring for information about traffic mirroring.
1-33
Chapter 1 QoS Configuration
Description
—
Required
By default, the burst function is
disabled.