Dldp Configuration; Performing Basic Dldp Configuration - H3C S3100 8C SI Operation Manual

Operation Manual – DLDP
H3C S3100 Series Ethernet Switches

1.3 DLDP Configuration

1.3.1 Performing Basic DLDP Configuration

Table 1-9 Perform basic DLDP configuration
Enter system view
Enable
DLDP
Set the authentication mode and
password
Set the interval of sending DLDP
packets
Set the delaydown timer
Set the DLDP handling mode
when an unidirectional link is
detected
Set the DLDP operating mode
Note the following when performing basic DLDP configuration.
DLDP works only when the link is up.
To ensure unidirectional links can be detected, make sure DLDP is enabled on
both sides; and the interval for sending advertisement packets, authentication
mode, and password are the same on both sides.
Operation
Enable DLDP
globally
Enter
Enable
Ethernet
DLDP
port view
on a
Enable
port
DLDP
1-10
Chapter 1 DLDP Configuration
Command
system-view
dldp enable
interface interface-type
interface-number
dldp enable
dldp authentication-mode
{ none | simple
simple-password | md5
md5-password }
dldp interval timer-value
dldp delaydown-timer
delaydown-time
dldp
unidirectional-shutdown
{ auto | manual }
dldp work-mode { enhance
| normal }
Description
—
Required.
By default,
DLDP is
disabled.
Optional.
By default, the
authentication
mode is none.
Optional.
By default, the
interval is 5
seconds.
Optional
By default, the
delaydown
timer expires
after 1 second
it is triggered.
Optional.
By default, the
handling mode
is auto.
Optional.
By default,
DLDP works in
normal mode.