Displaying Mac Address Table Information - H3C S3100 8C SI Operation Manual

Operation Manual – MAC Address Table Management
H3C S3100 Series Ethernet Switches
Follow these steps to configure the start port MAC address:
Enter system view
Configure the start port
MAC address
Note:
The start port MAC address must be a valid unicast address.
With the port MAC address configuration, the switch uses the MAC address of a port as
the source MAC address when sending the following Layer 2 PDUs out of the port:
LACP
STP
NDP/NTDP
GVRP
DLDP
Port MAC address configuration does not affect service packet forwarding.

1.3 Displaying MAC Address Table Information

Display information about
the MAC address table
Display the aging time of
the dynamic MAC
address entries in the
MAC address table
Display the configured
start port MAC address
To do...
system-view
port-mac
start-mac-address
To do...
display mac-address
[ display-option ]
display mac-address
aging-time
display port-mac
Use the command...
Use the command...
1-10
Chapter 1
MAC Address Table
Management
Remarks
—
Required
No start port MAC
address is configured by
default.
Remarks
Available in any view