Remote Loading Using Tftp - H3C S3100 8C SI Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
<Sysname> boot bootrom switch.btm
This will update Bootrom on unit 1.
Upgrading Bootrom, please wait...
Upgrade Bootrom succeeded!
<Sysname> reboot
After the switch restarts, the file switch.btm is used as the Boot ROM. It indicates that
the Boot ROM loading is finished.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except that
the file to be downloaded is the host software file, and that you need to use the boot
boot-loader command to select the host software used for the next startup of the
switch.
Note:
The steps listed above are performed in the Windows operating system, if you use
other FTP client software, refer to the corresponding user guide before operation.
Only the configuration steps concerning loading are listed here. For detailed
description on the corresponding configuration commands, refer to the
"FTP-SFTP-TFTP" part of this manual.

1.3.2 Remote Loading Using TFTP

The remote loading using TFTP is similar to that using FTP. The only difference is that
TFTP is used to load software to the switch, and the switch can only act as a TFTP
client.
Chapter 1 Boot ROM and Host Software
Continue? [Y/N] y
1-17
Loading