Displaying Monitor Link Configuration - H3C S3100 8C SI Operation Manual

Operation Manual – Smart Link-Monitor Link
H3C S3100 Series Ethernet Switches
Configure
a downlink
port for
the
Monitor
Link group
Caution:
A Smart Link/Monitor Link group with members cannot be deleted. A Smart Link
group as a Monitor Link group member cannot be deleted.
The Smart Link/Monitor Link function and the remote port mirroring function are
incompatible with each other.
If a single port is specified as a Smart Link/Monitor Link group member, do not use
the lacp enable command on the port or add the port to another dynamic link
aggregation group because doing so will cause the port to become an aggregation
group member.
Using the copy command on a port does not copy the Smart Link/Monitor Link group
member information configured on the port to any other port.

2.3 Displaying Monitor Link Configuration

After the above-mentioned configuration, you can use the display command in any
view to display the information about Monitor Link, so as to verify configuration result.
Table 2-5 Display Monitor Link configuration
Display the information
about one or all Monitor
Link groups
Operation
Configure the specified
link aggregation group as
a downlink port of the
Monitor Link group
Monitor
Configure
Link group
the
view
specified
Ethernet
port as a
downlink
Ethernet
port of the
port view
Monitor
Link group
Operation
display monitor-link group
{ group-id | all }
Chapter 2 Monitor Link Configuration
Command
link-aggregation group
group-id downlink
port interface-type
interface-number downlink
quit
interface interface-type
interface-number
port monitor-link group
group-id downlink
Command
2-5
Remarks
Required
Use either
approach
Remarks
You can use the display
command in any view.