Cluster Configuration Tasks; Configuring The Management Device - H3C S3100 8C SI Operation Manual

Operation Manual – Stack-Cluster
H3C S3100 Series Ethernet Switches
(or IP address) is found, the multicast packet will not be forwarded to the
downstream any more.
Note:
If the queried IP address has a corresponding ARP entry, but the MAC address
entry corresponding to the IP address does not exist, the trace of the device fails.
To trace a specific device using the tracemac command, make sure that all the
devices passed support the tracemac function.
To trace a specific device in a management VLAN using the tracemac command,
make sure that all the devices passed are within the same management VLAN as
the device to be traced.

2.2 Cluster Configuration Tasks

Before configuring a cluster, you need to determine the roles and functions the
switches play. You also need to configure the related functions, preparing for the
communication between devices within the cluster.
Complete the following tasks to configure cluster:

Configuring the Management Device

Configuring Member Devices
Managing a Cluster through the Management Device
Configuring the Enhanced Cluster Features
2.2.1 Configuring the Management Device
I. Management device configuration tasks
Complete the following tasks to configure management device:
Enabling NDP globally and on specific ports
Configuring NDP-related parameters
Enabling NTDP globally and on a specific port
Configuring NTDP-related parameters
Enabling the cluster function
Configuration task
Task
2-10
Chapter 2 Cluster
Remarks
Required
Required
Optional
Optional
Remarks
Required
Optional
Required
Optional
Required