Arp Configuration Example; Arp Basic Configuration Example - H3C S3100 8C SI Operation Manual

Operation Manual – ARP
H3C S3100 Series Ethernet Switches
Table 1-9 Display and debug ARP
Display specific ARP
mapping table entries
Display the ARP mapping
entries related to a specified
string in a specified way
Display the number of the
ARP entries of a specified
type
Display the statistics about
the untrusted ARP packets
dropped by the specified
port
Display the setting of the
ARP aging timer
Clear specific ARP entries

1.5 ARP Configuration Example

1.5.1 ARP Basic Configuration Example

I. Network requirement
Disable ARP entry check on the switch.
Set the aging time for dynamic ARP entries to 10 minutes.
Add a static ARP entry, with the IP address being 192.168.1.1, the MAC address
being 000f-e201-0000, and the outbound port being Ethernet1/0/10 of VLAN 1.
II. Configuration procedure
<Sysname> system-view
[Sysname] undo arp check enable
[Sysname] arp timer aging 10
[Sysname] arp static 192.168.1.1 000f-e201-0000 1 Ethernet1/0/10
Operation Command
display arp [ static | dynamic |
ip-address ]
display arp [ dynamic | static ] |
{ begin | include | exclude }
regular-expression
display arp count [ [ dynamic |
static ] [ | { begin | include |
exclude } regular-expression ] |
ip-address ]
display arp detection statistics
interface interface-type
interface-number
display arp timer aging
reset arp [ dynamic | static |
interface interface-type
interface-number ]
1-12
Chapter 1 ARP Configuration
Remarks
Available in any
view.
Available in user
view.