Operation Manual – PoE-PoE Profile
H3C S3100 Series Ethernet Switches
1.2.6 Configuring the PD Compatibility Detection Function
After the PD compatibility detection function is enabled, the switch can detect the PDs
that do not conform to the 802.3af standard and supply power to them.
After the PoE feature is enabled, perform the following configuration to enable the PD
compatibility detection function.
Table 1-7 Configure the PD compatibility detection function
Enter system view
Enable the PD
compatibility detection
function
1.2.7 Configuring PoE Over-Temperature Protection on the Switch
If this function is enabled, the switch disables the PoE feature on all ports when its
internal temperature exceeds 65°C (149°F) for self-protection, and restores the PoE
feature settings on all its ports when the temperature drops below 60°C (140°F).
Table 1-8 Configure PoE over-temperature protection on the switch
Enter system view
Enable PoE
over-temperature
protection on the switch
Note:
When the internal temperature of the switch decreases from X (X>65°C, or X>149°F)
to Y (60°C≤Y<65°C, or 140°F≤Y<149°F), the switch still keeps the PoE function
disabled on all the ports.
When the internal temperature of the switch increases from X (X<60°C, or X<140°F)
to Y (60°C<Y≤65°C, or 140°F <Y≤149°F), the switch still keeps the PoE function
enabled on all the ports.
Operation
system-view
poe legacy enable
Operation
system-view
poe
temperature-protection
enable
Command
Command
1-6
Chapter 1 PoE Configuration
Description
—
Required
Disabled by default.
Description
—
Optional
Enabled by default.