Configuring Traffic Redirecting - H3C S3100 8C SI Operation Manual

S3100 series ethernet switches
Table of Contents

Advertisement

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches
I. Configuration prerequisites
The port on which port rate limiting configuration is to be performed is determined.
The target rate and the direction of rate limiting (inbound or outbound) are
determined.
II. Configuration procedure
Table 1-23 Configure port rate limiting
Operation
Enter system view
Enter Ethernet
port view
Configure port
rate limiting
III. Configuration example
Configure port rate limiting for inbound packets on Ethernet 1/0/1.
The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] line-rate inbound 1024

1.4.7 Configuring Traffic Redirecting

Note:
Only H3C S3100-EI series switches support this configuration.
Refer to section
I. Configuration prerequisites
The ACL rules used for traffic classification are defined. Refer to the ACL module
of this manual for information about defining ACL rules.
The traffic redirecting destination is determined.
Command
system-view
interface interface-type
interface-number
line-rate { inbound | outbound }
target-rate
Traffic Redirecting
for information about traffic redirecting.
1-27
Chapter 1 QoS Configuration
Description
Required
By default, port rate
limiting is disabled.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H3C S3100 8C SI and is the answer not in the manual?

This manual is also suitable for:

S3100-si seriesS3100-ei series

Table of Contents