H3C S3100 8C SI Operation Manual page 260

Operation Manual – MSTP
H3C S3100 Series Ethernet Switches
Configure the mode a port
recognizes and sends
MSTP packets
Configure the MSTP
operation mode
Configure the maximum
hop count of an MST
region
Configure the network
diameter of the switched
network
Configure the MSTP
time-related parameters
Configure the timeout
time factor
Configure the maximum
transmitting speed of the
port
Configure the current port
as an edge port
Specify whether the link
connected to a port is a
point-to-point link
Note:
In a network containing switches with both GVRP and MSTP enabled, GVRP packets
are forwarded along the CIST. If you want to advertise packets of a specific VLAN
through GVRP, be sure to map the VLAN to the CIST when configuring the MSTP
VLAN mapping table (the CIST of a network is spanning tree instance 0).
Operation
Optional
Optional
Optional
Optional
The default value is
recommended.
Optional
The default values are
recommended.
Optional
Optional
The default value is
recommended.
Optional
Optional
Description
1-19
Chapter 1 MSTP Configuration
Related section
Section 1.3.5
"Configuring the Mode a
Port Recognizes and
Sends MSTP Packets"
Section 1.3.6
"Configuring the MSTP
Operation Mode"
Section 1.3.7
"Configuring the
Maximum Hop Count of
an MST Region"
Section 1.3.8
"Configuring the Network
Diameter of the Switched
Network"
Section 1.3.9
"Configuring the MSTP
Time-related Parameters"
Section 1.3.10
"Configuring the Timeout
Time Factor"
Section 1.3.11
"Configuring the
Maximum Transmitting
Speed on the Current
Port"
Section 1.3.12
"Configuring the Current
Port as an Edge Port"
Section 1.3.13
"Specifying Whether the
Link Connected to a Port
Is Point-to-point Link"