Configuring The Quiet Mac Function On A Port; Displaying And Debugging Mac Authentication - H3C S3100 8C SI Operation Manual

Operation Manual – MAC Address Authentication
H3C S3100 Series Ethernet Switches
Caution:
If both the limit on the number of MAC address authentication users and the limit on
the number of users configured in the port security function are configured for a port,
the smaller value of the two configured limits is adopted as the maximum number of
MAC address authentication users allowed to access this port. Refer to the Port
Security manual for the description on the port security function.
You cannot configure the maximum number of MAC address authentication users
for a port if any user connected to this port is online.

1.4.4 Configuring the Quiet MAC Function on a Port

You can configure whether to enable the quiet MAC function on a port. When this
function is enabled, the MAC address connected to this port will be set as a quiet MAC
address if its authentication fails. When this function is disabled, the MAC address will
not become quiet no matter whether the authentication is failed.
Table 1-5 Configure the quiet MAC function on a port
Enter system view
Eneter Ethernet port view
Configure quiet MAC
function on the port

1.5 Displaying and Debugging MAC Authentication

After the above configuration, you can execute the display command in any view to
display system running of MAC Authentication configuration, and to verify the effect of
the configuration. You can execute the reset command in user view to clear the
statistics of MAC Authentication.
Table 1-6 Display and debug MAC Authentication
Display global or on-port
information about MAC
authentication
Operation
system-view
interface interface-type
interface-number
mac-authenticiaon
intrusion-mode
block-mac enable
Operation
display
mac-authentication
[ interface interface-list ]
Chapter 1 MAC Authentication Configuration
Command
Command
1-8
Description
—
—
Required
Enabled by default.
Description
Available in any view