H3C S3100 8C SI Operation Manual page 857

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches
Configure dns-server
Configure the source IP
address
Configure the source port
Configure the number of
probes per test
Configure the maximum
number of history records
that can be saved
Configure the automatic
test interval
Configure the probe
timeout time
Configure the type of
service
Configure the type of
HTTP operation
Operation
dns-server ip-address
source-ip ip-address
source-port
port-number
count times
history-records
number
frequency interval
timeout time
tos value
http-operation { get |
post }
Chapter 1 HWPing Configuration
Command
By default, no IP address of
the DNS server is
configured.
Optional
By default, no source IP
address is configured.
Optional
By default, no source port is
configured.
Optional
By default, each test makes
one probe.
Optional
By default, the maximum
number is 50.
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test
will be made.
Optional
By default, a probe times out
in three seconds.
Optional
By default, the service type
is zero.
Optional
By default, the type of HTTP
operation is get, that is, the
HTTP operation will get data
from the HTTP server.
1-11
Description
Required: When you use
H3C S3100-EI Series
Switches as HWPing
Client for http test and
set the destination
address as host name.
This command can not
be supported when you
use H3C S3100-SI
Series Switches
HWPing Client for http
test.
as