H3C S3100 8C SI Operation Manual page 25

Operation Manual – CLI
H3C S3100 Series Ethernet Switches
password is set, the system prompts "%Password is not set" when you attempt to
switch to a higher user level. In this case, you cannot pass the super password
authentication.
Table 1-4
switching, which can only be performed by level-3 users.
Table 1-4 Set a password for use level switching
Enter system view
Set the super password
for user level switching
III. Adopting HWTACACS authentication for user level switching
To implement HWTACACS authentication for user level switching, a level-3 user must
perform the commands listed in
scheme used for low-to-high user level switching. With HWTACACS authentication
enabled, you can pass the HWTACACS authentication successfully only after you
provide the right user name and the corresponding password as prompted. Note that if
you have passed the HWTACACS authentication when logging in to the switch, only
the password is required.
Table 1-5
switching, which can only be performed by Level-3 users.
Table 1-5 Set the HWTACACS authentication scheme for user level switching
Operation
Enter system view
Enter ISP domain view
Set the HWTACACS
authentication scheme
for user level switching
lists the operations to configure super password authentication for user level
Operation
system-view
super password [ level
level ] { cipher | simple }
password
lists the operations to configure HWTACACS authentication for user level
system-view
domain domain-name
authentication super
hwtacacs-scheme
hwtacacs-scheme-name
Command
Table 1-5 to configure the HWTACACS authentication
Command
1-5
Chapter 1 CLI Configuration
Remarks
—
Required
By default, the super
password is not set.
Description
—
—
Required
By default, the HWTACACS
authentication scheme for user
level switching is not set.