Displaying Hwping Configuration; Hwping Configuration Example; Icmp Test - H3C S3100 8C SI Operation Manual

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches
Enable the HWPing client
to send Trap messages
Configure the number of
consecutive unsuccessful
HWPing tests before Trap
output
Configure the number of
consecutive unsuccessful
HWPing probes before
Trap output

1.2.3 Displaying HWPing Configuration

After the above-mentioned configuration, you can use the display commands to view
the results of the latest test and history information.
Table 1-15 Display HWPing test results
Operation
Display test history
Display the results of
the latest test

1.3 HWPing Configuration Example

1.3.1 ICMP Test

I. Network requirements
An H3C S3100 series Ethernet switch serves as the HWPing client. A HWPing ICMP
test between the switch and another switch uses ICMP to test the round trip time (RTT)
for packets generated by the HWPing client to travel to and back from the destination
switch.
Operation
send-trap { all |
{ probefailure |
testcomplete |
testfailure }* }
test-failtimes times
probe-failtimes times
display hwping history
[ administrator-name operation-tag ]
display hwping results
[ administrator-name operation-tag ]
Chapter 1 HWPing Configuration
Command
Command
1-20
Description
Required
By default, Trap sending
is disabled.
Optional
By default, Trap
messages are sent each
time a test fails.
Optional
By default, Trap
messages are sent each
time a probe fails.
Description
Available in any
view.