Operation Manual – Login
H3C S3100 Series Ethernet Switches
Chapter 6 Logging in through NMS
6.1 Introduction
You can also log into a switch through a network management station (NMS), and then
configure and manage the switch through the agent module on the switch. Simple
network management protocol (SNMP) is applied between the NMS and the agent.
Refer to the SNMP-RMON part for related information.
To log into a switch through an NMS, you need to perform related configuration on both
the NMS and the switch.
Table 6-1 Requirements for logging into a switch through an NMS
Item
Switch
NMS
6.2 Connection Establishment Using NMS
NMS
Figure 6-1 Network diagram for logging in through an NMS
The IP address of the VLAN interface of the switch is configured.
The route between the NMS and the switch is reachable. (Refer
to the IP Address Configuration – IP Performance Configuration
and Routing Protocol parts for related information.)
The basic SNMP functions are configured. (Refer to the
SNMP-RMON part for related information.)
The NMS is properly configured. (Refer to the user manual of
your NMS for related information.)
Switch
Network
6-1
Chapter 6 Logging in through NMS
Requirement