Ipv6 Configuration Example; Ipv6 Unicast Address Configuration - H3C S3100 8C SI Operation Manual

Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches
Clear IPv6 dynamic domain
name cache information
Clear IPv6 neighbor information
Clear the statistics of IPv6
packets
Clear the statistics of all IPv6
TCP packets
Clear the statistics of all IPv6
UDP packets
Note:
The display dns domain and display dns server commands are the same as those
of IPv4 DNS. For details about the commands, refer to DNS.

1.3 IPv6 Configuration Example

1.3.1 IPv6 Unicast Address Configuration

I. Network requirements
Two switches are directly connected through two Ethernet ports. The Ethernet ports
belong to VLAN 1. IPv6 addresses are configured for the interface Vlan-interface1 on
each switch to verify the connectivity between the two switches. The global unicast
address of Switch A is 3001::1/64, and the global unicast address of Switch B is
3001::2/64.
II. Network diagram
Figure 1-5 Network diagram for IPv6 address configuration
III. Configuration procedure
1) Configure Switch A.
To do...
1-19
Use the command...
reset dns ipv6 dynamic-host
reset ipv6 neighbors [ all |
dynamic | interface
interface-type interface-number |
static ]
reset ipv6 statistics
reset tcp ipv6 statistics
reset udp ipv6 statistics
Chapter 1 IPv6 Configuration
Remarks
Available in
user view