Enabling The Burst Function - H3C S3100 8C SI Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches
Table 1-32 Generate traffic statistics on packets passing a port and matching specific
ACL rules
Enter system view
Enter Ethernet port view
Generate the statistics on the packets
matching specific ACL rules
Clear the statistics on the packets
matching specific ACL rules
Note:
The traffic accounting function configured on a VLAN is only applicable to packets
tagged with 802.1Q header.
III. Configuration example
Ethernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
Generate statistics on the packets sourced from the 10.1.1.0/24 network segment.
Clear the statistics.
1) Method I
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-statistic inbound ip-group 2000
[Sysname-Ethernet1/0/1] reset traffic-statistic inbound ip-group 2000
2) Method II
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-statistic vlan 2 inbound ip-group 2000
[Sysname] reset traffic-statistic vlan 2 inbound ip-group 2000

1.4.10 Enabling the Burst Function

Refer to section
Operation
Burst for information about the burst function.
1-32
Chapter 1 QoS Configuration
Command
system-view
interface interface-type
interface-number
traffic-statistic
inbound acl-rule
reset traffic-statistic
inbound acl-rule
Description
—
—
Required
Optional