Setting To Output System Information To The Console - H3C S3100 8C SI Operation Manual

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches
Set to display the UTC time
zone in the output information
of the information center

1.2.4 Setting to Output System Information to the Console

I. Setting to output system information to the console
Table 1-7 Set to output system information to the console
Operation
Enter system view
Enable the information
center
Enable system
information output to
the console
Configure the output
rules of system
information
Set the format of time
stamp in the output
information
Note:
To view the debugging information of some modules on the switch, you need to set the
type of the output information to debug when configuring the system information output
rules, and use the debugging command to enable debugging for the corresponding
modules.
Operation
system-view
info-center enable
info-center console
channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Command
info-center timestamp
utc
Command
1-10
Chapter 1 Information Center
Description
Required
By default, no UTC
time zone is
displayed in the
output information
Description
—
Optional
Enabled by default.
Optional
By default, the switch uses
information channel 0 to
output log/debugging/trap
information to the console.
Optional
Refer to Table 1-8 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is boot.