H3C S3100 8C SI Operation Manual page 400

Operation Manual – AAA
H3C S3100 Series Ethernet Switches
Set the status of the ISP
domain
Set the maximum number
of access users that the
ISP domain can
accommodate
Set the idle-cut function
Set the
accounting-optional
switch
Set the messenger
function
Set the self-service server
location function
Note that:
On an S3100 series switch, each access user belongs to an ISP domain. You can
configure up to 16 ISP domains on the switch. When a user logs in, if no ISP
domain name is carried in the user name, the switch assumes that the user
belongs to the default ISP domain.
If you have configured to use "." as the delimiter, for a user name that contains
multiple ".", the first "." will be used as the domain delimiter.
If you have configured to use "@" as the delimiter, the "@" must not appear more
than once in the user name.
If the system does not find any available accounting server or fails to communicate
with any accounting server when it performs accounting for a user, it does not
disconnect the user as long as the accounting optional command has been
executed, though it cannot perform accounting for the user in this case.
Operation
state { active | block }
access-limit { disable |
enable
max-user-number }
idle-cut { disable |
enable minute flow }
accounting optional
messenger time { enable
limit interval | disable }
self-service-url { disable
| enable url-string }
Command
2-3
Chapter 2 AAA Configuration
Remarks
Optional
By default, an ISP domain
is in the active state, that
is, all the users in the
domain are allowed to
request network service.
Optional
By default, there is no limit
on the number of access
users that the ISP domain
can accommodate.
Optional
By default, the idle-cut
function is disabled.
Optional
By default, the
accounting-optional
switch is off.
Optional
By default, the messenger
function is disabled.
Optional
By default, the
self-service server
location function is
disabled.