H3C S3100 8C SI Operation Manual page 853

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches
Configure the source IP
address
Configure the number of
probes per test
Configure the packet size
Configure the maximum
number of history records
that can be saved
Configure the automatic
test interval
Configure the probe
timeout time
Configure the type of
service (ToS)
Start the test
Display test results
Note:
For a HWPing ICMP test, if no IP address is configured for the source interface
configured through the source-interface command, the test cannot be performed; if a
source IP address has already been configured through the source-ip command, the
source-interface command does not take effect.
2) Configuring DHCP test on HWPing client
Operation
source-ip ip-address
count times
datasize size
history-records number
frequency interval
timeout time
tos value
test-enable
display hwping results
[ admin-name
operation-tag ]
Chapter 1 HWPing Configuration
Command
1-7
Description
Optional
By default, no source IP
address is configured.
Optional
By default, each test
makes one probe.
Optional
By default, the packet size
is 56 bytes.
Optional
By default, the maximum
number is 50.
Optional
By default, the automatic
test interval is zero
seconds, indicating no
automatic test will be
made.
Optional
By default, a probe times
out in three seconds.
Optional
By default, the service
type is zero.
Required
Required
Available in any view.