Configuring Traffic Shaping; Configuring Port Rate Limiting - H3C S3100 8C SI Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches
[Sysname] traffic-limit vlan 2 inbound ip-group 2000 128 exceed remark-dscp
56

1.4.5 Configuring Traffic Shaping

Note:
Only H3C S3100-EI series switches support this configuration.
Refer to section
shaping.
I. Configuration prerequisites
The maximum traffic rate and the burst size are determined.
The port where traffic shaping is to be configured is determined.
II. Configuration procedure
Table 1-22 Configure traffic shaping
Operation
Enter system view
Enter Ethernet port
view
Configure traffic
shaping
III. Configuration examples
# Perform traffic shaping for all the traffic to be transmitted through Ethernet 1/0/1, with
the maximum traffic rate being 640 kbps and the burst size being 16 KB.
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-shape 640 16

1.4.6 Configuring Port Rate Limiting

Refer to section
target-rate argument is committed information rate (CIR).
Traffic Policing and Traffic Shaping
Command
system-view
interface interface-type
interface-number
traffic-shape queue
queue-id max-rate
burst-size
Port Rate Limiting for information about port rate limiting. Note that, the
1-26
Chapter 1 QoS Configuration
for information about traffic
Description
—
—
Required
Traffic shaping is not enabled
by default.