H3C S3100 8C SI Operation Manual page 906

Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches
Joined group address(es):
FF02::1:FF00:2
FF02::1:FF00:2006
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# On Switch A, ping the link-local address and global unicast address of Switch B. If the
configurations are correct, the above two types of IPv6 addresses can be pinged.
Caution:
When you use the ping ipv6 command to verify the reachability of the destination, you
must specify the "–i" keyword if the destination address is a link-local address. For the
operation of IPv6 ping, refer to section
[SwitchA-Vlan-interface1]ping
Vlan-interface 1
PING FE80::2E0:FCFF:FE00:2006 : 56
Reply from FE80::2E0:FCFF:FE00:2006
bytes=56 Sequence=1 hop limit=64
Reply from FE80::2E0:FCFF:FE00:2006
bytes=56 Sequence=2 hop limit=64
Reply from FE80::2E0:FCFF:FE00:2006
bytes=56 Sequence=3 hop limit=64
Reply from FE80::2E0:FCFF:FE00:2006
bytes=56 Sequence=4 hop limit=64
Reply from FE80::2E0:FCFF:FE00:2006
bytes=56 Sequence=5 hop limit=64
--- FE80::2E0:FCFF:FE00:2006 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 6/22/77 ms
[SwitchA-Vlan-interface1] ping ipv6 3001::2
PING 3001::2 : 56
Reply from 3001::2
2.2.1 "IPv6
ipv6
data bytes, press CTRL_C to break
time = 77 ms
time = 6 ms
time = 6 ms
time = 7 ms
time = 14 ms
data bytes, press CTRL_C to break
1-21
Chapter 1 IPv6 Configuration
Ping".
FE80::2E0:FCFF:FE00:2006 -i