H3C S3100 8C SI Operation Manual page 863

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches
Configure the test type
Configure the destination
address
Configure the destination
port
Configure the source IP
address
Configure the source port
Configure the number of
probes per test
Configure the maximum
number of history records
that can be saved
Configure the data packet
size
Operation
test-type { udpprivate |
udppublic }
destination-ip ip-address
destination-port
port-number
source-ip ip-address
source-port port-number
count times
history-records number
datasize size
Chapter 1 HWPing Configuration
Command
1-17
Description
Required
By default, the test type is
ICMP.
Required
This IP address and the
one configured on the
HWPing server for
listening service must be
the same.
By default, no destination
address is configured.
Required in
Udpprivate test
A Udppublic test is a
UDP connection test
on port 7. Use the
hwping-server
udpecho ip-address 7
command on
server to configure the
listening service port;
otherwise the test will
fail. No port number
needs to be configured
on the client;
destination
number configured on
the client will not take
effect.
By default,
destination
number is configured.
Optional
By default, no source IP
address is configured.
Optional
By default, no source port
is specified.
Optional
By default, one probe is
made per test.
Optional
By default, the maximum
number is 50.
Optional
By default, the data
packet size is 100 bytes.
a
the
any
port
no
port