Ipv6 Telnet - H3C S3100 8C SI Operation Manual

Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches
I. Configuration preparation
Enable TFTP on the TFTP server and specify the path to download or upload files. For
specific operations, refer to TFTP server configuration specifications.
II. IPv6 TFTP configuration
You can use the commands listed in
upload files to a TFTP server.
Table 2-3 Download/upload files to TFTP servers
Download/ Upload files
from TFTP server
Caution:
When you use the tftp ipv6 command to connect to the TFTP server, you must specify
the "–i" keyword if the destination address is a link-local address.

2.2.4 IPv6 Telnet

Telnet protocol belongs to application layer protocols of the TCP/IP protocol suite, and
is used to provide remote login and virtual terminals. The device can be used either as
a Telnet client or a Telnet server.
As the following figure shows, the Host is running Telnet client application of IPv6 to set
up an IPv6 Telnet connection with Device A, which serves as the Telnet server. If
Device A again connects to Device B through Telnet, the Device A is the Telnet client
and Device B is the Telnet server.
Figure 2-2 Provide Telnet services
To do...
tftp ipv6 remote-system
[ -i interface-type
interface-number ] { get |
put } source-filename
[ destination-filename ]
Chapter 2 IPv6 Application Configuration
Table 2-3 to download files from a TFTP server or
Use the command...
2-3
Remarks
Required
Available in user view