Applying A Qos Profile - H3C S3100 8C SI Operation Manual

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches
Operation
Configure traffic
policing
Configure packet
filtering
Configure priority
marking

2.2.2 Applying a QoS Profile

You can configure to apply a QoS profile dynamically or simply apply a QoS profile
manually.
I. Configuration prerequisites
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both
globally and on the port, and the authentication mode is determined. For
information about 802.1x, refer to the 802.1x and System Guard module of this
manual.
To apply a QoS profile manually, make sure the port to which the QoS profile is to
be applied is determined.
The QoS profile to be applied is determined.
II. Configuration procedure
Table 2-3 Configure to apply a QoS profile dynamically
Enter system view
Enter Ethernet port view
traffic-limit inbound acl-rule
target-rate [ burst-bucket
burst-bucket-size ] [ conform
con-action ] [ exceed
exceed-action ]
[ meter-statistic ]
packet-filter inbound
acl-rule
traffic-priority inbound
acl-rule { dscp dscp-value |
cos cos-value |
local-precedence
pre-value }*
Operation
system-view
interface
interface-type
interface-number
Chapter 2 QoS Profile Configuration
Command
Command
—
—
2-3
Description
Optional
Optional
Refer to the ACL module
of this manual for
information about packet
filtering.
Optional
Description