Displaying Protocol-Based Vlan Configuration; Protocol-Based Vlan Configuration Example - H3C S3100 8C SI Operation Manual

Operation Manual – VLAN
H3C S3100 Series Ethernet Switches
II. Configuration procedure
Follow these steps to associate a port with the protocol-based VLAN:
Enter system view
Enter port view
Associate the port with
the specified
protocol-based VLAN

2.3.4 Displaying Protocol-Based VLAN Configuration

Display the information about the
protocol-based VLAN
Display the protocol information
and protocol indexes configured
on the specified VLAN
Display the protocol information
and protocol indexes configured
on the specified port

2.3.5 Protocol-Based VLAN Configuration Example

I. Network requirements
As shown in
1/0/10 on the S3100 switch.
IP network and AppleTalk network workstations (hosts) coexist in the Workroom.
The S3100 switch connects to VLAN 100 (using IP network) through Ethernet
1/0/11 and to VLAN 200 (using AppleTalk network) through Ethernet 1/0/12.
Configure the switch to automatically assign the IP and AppleTalk packets to
proper VLANs for transmission, so as to ensure the normal communication
between the workstations and servers.
To do...
system-view
interface interface-type
interface-number
port hybrid protocol-vlan
vlan vlan-id { protocol-index
[ to protocol-index-end ] | all }
To do...
Figure 2-2, Workroom connects to the LAN through port Ethernet
Use the command...
Use the command...
display vlan [ vlan-id [ to vlan-id ]
| all | dynamic | static]
display protocol-vlan vlan
{ vlan-id [ to vlan-id ] | all }
display protocol-vlan interface
{ interface-type interface-number
[ to interface-type
interface-number ] | all }
2-10
Chapter 2 VLAN Configuration
Remarks
—
—
Required
By default, a port is not
associated with any
protocol-based VLAN.
Remarks
Available in
any view