Setting To Output System Information To A Monitor Terminal - H3C S3100 8C SI Operation Manual

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches
Note:
Make sure that the debugging/log/trap information terminal display function is enabled
(use the terminal monitor command) before you enable the corresponding terminal
display function by using the terminal debugging, terminal logging, or terminal
trapping command.

1.2.5 Setting to Output System Information to a Monitor Terminal

System information can also be output to a monitor terminal, which is a user terminal
that has login connections through the AUX, VTY, or TTY user interface.
I. Setting to output system information to a monitor terminal
Table 1-10 Set to output system information to a monitor terminal
Operation
Enter system view
Enable the information
center
Enable system
information output to
Telnet terminal or
dumb terminal
Configure the output
rules of system
information
Set the format of time
stamp in the output
information
Command
system-view
info-center enable
info-center monitor
channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
1-12
Chapter 1 Information Center
Description
—
Optional
Enabled by default.
Optional
By default, a switch outputs
log/debugging/trap
information to a user
terminal through information
channel 1.
Optional
Refer to Table 1-8 for the
default output rules of
system information.
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is boot.