H3C S3100 8C SI Operation Manual page 68

Operation Manual – Login
H3C S3100 Series Ethernet Switches
Operation
Set the timeout time for
the user interface
Note that if you configure to authenticate the users in the scheme mode, the command
level available to the users logging into the switch depends on the user privilege level
level command and the service-type { ftp | lan-access | { ssh | telnet | terminal }*
[ level level ] } command, as listed in
Table 3-7 Determine the command level when users logging into switches are
authenticated in the scheme mode
Authenticati
on mode
authenticatio
n-mode
scheme
[ command-a
uthorization ]
Command
idle-timeout
[ seconds ]
Table
Scenario
User type
The user privilege level level
command is not executed, and
the service-type command does
not
command level.
The user privilege level level
command is not executed, and
VTY users that
the
are
specifies the available command
AAA&RADIUS
level.
authenticated
The user privilege level level
or locally
command is executed, and the
authenticated
service-type command does not
specify the available command
level.
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
3-11
Chapter 3 Logging in through Telnet
Description
Optional
The default timeout time of a
user interface is 10 minutes.
With the timeout time being
10 minutes, the connection to
minutes
a user interface is terminated
if no operation is performed in
the user interface within 10
minutes.
You can use the idle-timeout
0 command to disable the
timeout function.
3-7.
Command
specify the available
service-type command
Command
level
Level 0
Determined
by the
service-type
command
Level 0
Determined
by the
service-type
command