Configuring Extended Trap - H3C S3100 8C SI Operation Manual

Operation Manual – SNMP-RMON
H3C S3100 Series Ethernet Switches
Set the destination for
Trap messages
Set the source address
for Trap messages
Set the size of the queue
used to hold the Traps to
be sent to the destination
host
Set the aging time for
Trap messages

1.3.2 Configuring Extended Trap

The extended Trap includes the following.
"Interface description" and "interface type" are added into the linkUp/linkDown
Trap message. When receiving this extended Trap message, NMS can
immediately determine which interface on the device fails according to the
interface description and type.
In all Trap messages sent from the information center to the log server, a MIB
object name is added after the OID field of the MIB object. The name is for your
better understanding of the MIB object.
Table 1-5 Configure extended Trap
Operation
Enter system view
Configure
extended Trap
Operation
Quit to
quit
system view
snmp-agent target-host trap
address udp-domain { ip-address }
[ udp-port port-number ] params
securityname security-string [ v1 |
v2c | v3 {authentication | privacy } ]
snmp-agent trap source
interface-type interface-number
snmp-agent trap queue-size size
snmp-agent trap life seconds
Command
system-view
snmp-agent trap
ifmib link extended
Command
—
Optional
By default, the linkUp/linkDown Trap
message adopts the standard format
defined in IF-MIB. For details, refer to
RFC 1213.
1-7
Chapter 1 SNMP Configuration
Description
Required
Optional
Optional
The default is
100.
Optional
120 seconds
by default.
Description