H3C S3100 8C SI Operation Manual page 898

S3100 series ethernet switches
Table of Contents

Advertisement

Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches
Table 1-6 Configure a static neighbor entry
To do...
Enter system view
Configure a static
neighbor entry
II. Configure the maximum number of neighbors dynamically learned
The device can dynamically acquire the link-layer address of a neighbor node through
NS and NA messages and add it to the neighbor table. Too large a neighbor table may
lead to the forwarding performance degradation of the device. Therefore, you can
restrict the size of the neighbor table by setting the maximum number of neighbors that
an interface can dynamically learn. When the number of dynamically learned neighbors
reaches the threshold, the interface will stop learning neighbor information.
Table 1-7 Configure the maximum number of neighbors dynamically learned:
Enter system view
Enter VLAN interface view
Configure the maximum
number of neighbors
dynamically learned by an
interface
III. Configure the attempts to send an ns message for duplicate address
detection
The device sends a neighbor solicitation (NS) message for duplicate address detection.
If the device does not receive a response within a specified time (set by the ipv6 nd ns
retrans-timer command), the device continues to send an NS message. If the device
still does not receive a response after the number of attempts to send an NS message
reaches the maximum, the device judges the acquired address is available.
Table 1-8 Configure the attempts to send an NS message for duplicate address
detection
Enter system view
Enter VLAN interface view
system-view
ipv6 neighbor ipv6-address mac-address
{ vlan-id port-type port-number | interface
interface-type interface-number }
To do...
system-view
interface interface-type
interface-number
ipv6 neighbors
max-learning-num
number
To do...
system-view
interface interface-type
interface-number
Use the command...
Use the command...
Use the command...
1-13
Chapter 1 IPv6 Configuration
Remarks
Required
Remarks
Optional
The default value is 2,048
Remarks

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H3C S3100 8C SI and is the answer not in the manual?

This manual is also suitable for:

S3100-si seriesS3100-ei series

Table of Contents