Tcp Test (Tcpprivate Test) On The Specified Ports - H3C S3100 8C SI Operation Manual

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches

1.3.7 TCP Test (Tcpprivate Test) on the Specified Ports

I. Network requirements
Both the HWPing client and the HWPing server are H3C S3100 series Ethernet
switches. Perform a HWPing Tcpprivate test to test time required to establish a TCP
connection between this end (Switch A) and the specified destination end (Switch B),
with the port number set to 8000.
II. Network diagram
Figure 1-8 Network diagram for the Tcpprivate test
III. Configuration procedure
Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
<Sysname> system-view
[Sysname] hwping-server enable
[Sysname] hwping-server tcpconnect 10.2.2.2 8000
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and
test tag to "tcpprivate".
[Sysname] Hwping administrator tcpprivate
# Configure the test type as tcpprivate.
[Sysname-hwping-administrator-tcpprivate] test-type tcpprivate
# Configure the IP address of the HWPing server as 10.2.2.2.
[Sysname-hwping-administrator-tcpprivate] destination-ip 10.2.2.2
# Configure the destination port on the HWPing server.
[Sysname-hwping-administrator-tcpprivate] destination-port 8000
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-tcpprivate] count 10
# Set the probe timeout time to 5 seconds.
Chapter 1 HWPing Configuration
1-33