Configuring Rip Route Redistribution; Configuring Rip Network Optimization; Configuring Rip Timers - 3Com 4510G Configuration Manual

To do...
Enter system view
Enter RIP view
Configure a priority for RIP

Configuring RIP Route Redistribution

If a router runs RIP and other routing protocols, you can configure RIP to redistribute static or direct
routes.
Follow these steps to configure RIP route redistribution:
To do...
Enter system view
Enter RIP view
Configure a default metric for
redistributed routes
Redistribute routes from
another protocol
Only active routes can be redistributed. You can use the display ip routing-table protocol command
to display route state information.

Configuring RIP Network Optimization

Complete the following tasks before configuring RIP network optimization:
Configure network addresses for interfaces, and make neighboring nodes reachable to each
other;
Configure RIP basic functions.

Configuring RIP Timers

Follow these steps to configure RIP timers:
To do...
Enter system view
Enter RIP view
Use the command...
system-view
rip [ process-id ]
preference [ route-policy
route-policy-name ] value
Use the command...
system-view
rip [ process-id ]
default cost value
import-route protocol
[ process-id | all-processes ]
[ cost cost | route-policy
route-policy-name | tag tag ] *
Use the command...
system-view
rip [ process-id ]
3-11
Remarks
––
––
Optional
100 by default
Remarks
––
––
Optional
The default metric of a
redistributed route is 0 by
default.
Required
No redistribution is
configured by default.
Remarks
––
––