Out Of Paper; Load Tray 1 (Mpt) With [Size] [Type]; Check The Following For Evidence Of Fault Or Damage - Xerox 6250DT - Phaser Color Laser Printer Service Manual

Out of Paper; Load Tray 1 (MPT) with [size] [type]

■
Remove Tray 1 and inspect the tray cavity of the printer to ensure that it is
free of obstructions or debris.
■
Ensure that the tray is loaded with supported media.
■
Ensure that the media guides are properly adjusted.
■
Reinstall the tray.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MPT No Paper Sensor, PL 6.1.4
MPT actuator, PL 6.1.37
Troubleshooting Procedure Table
Steps Actions and Questions
Fill Tray 1 (MPT) with paper.
1
Does the error occur even if Tray 1 is full?
Check the following for evidence of fault
2
or damage:
MPT No Paper Sensor, PL 6.1.4
MPT actuator, PL 6.1.37
Use service diagnostics to test the MPT
3
No Paper Sensor
Does the Sensor function correctly?
Replace the MPT No Paper Sensor.
4
Does the error recur after the sensor is
replaced?
Troubleshoot using the wiring diagram
5
"Paper Feed" on page 10-25.
Does the problem recur after any
defective parts are replaced?
3-56
Wiring and Plug/Jack Map References
"Paper Feed" on page 10-25
Phaser 6250 Color Laser Printer Service Manual
Yes
Go to Step 2.
Replace the parts
concerned.
Replace the
Engine Control
Board, page 8-107
Go to Step 5.
Replace the
Engine Control
Board, page 8-107
No
Complete.
Go to Step 3.
Go to Step 4.
Complete.
Complete