RRP 6-11 H-Tra Input Path & Face Up Bin Full
Sensors (PL 20.3)
Fig 6-9 H-Tra Input Path & Face Up Bin Full Sensors
Removal
1.
Open the top cover of the Horizontal Transport Assembly Top Cover, and
unhook the Sensor Cover (PL 20.3.14) at two places from the back of the
Horizontal Transport, and remove the Sensor Cover. (Figure 1)
2.
Remove the screw that secures the mounting bracket for the Horizontal
Transport Input Path Sensor (PL 20.3.12) and remove the bracket.
3.
Release the Pinch Roller (PL 20.3.24) from the Idler Bracket (PL 20.2.28).
4.
Unplug the connector (P/J259) of the Horizontal Transport Harness Assembly
(PL 20.2.24) from the Face Down Bin Full Sensor (PL 20.3.19).
5.
Tighten the latch of the MINI Clamp and remove the Clamp MINI from the
Bracket Path Sensor.
6.
Unhook the sensor at fourplaces, and remove the Sensor from the Bracket.
7.
Unplug the connector (P/J275M) of the Horizontal Transport Harness
Assembly from the Sensor.
8.
Unhook theSensor at four places, and remove the Sensor from the bottom of
the Horizontal Transport.
Replacement
1.
Reverse the above procedure.
6-724
DocuPrint N4525 Network Laser Printer - Service Guide
Figure 1
Figure 2
S4525-431