Wi-Fi; Wi-Fi Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones

Wi-Fi

Wi-Fi feature enables you to connect the phones to the organization's wireless network. Wi-Fi feature is only applic-
able to
T57W/T54W/T53W/T53/T53C/T48U/T48S/T48G/T46U/T46S/T46G/T43U/T42U/T42S/T41S/T29G/T27G/CP920/CP9-
25/CP935W phones.
You can configure the phones to operate in IPv4, IPv6, or dual-stack (IPv4/IPv6) mode, and configure IPv4 or IPv6
wireless network settings manually.
Note
: To use Wi-Fi feature on T53/T53C/T48U/T48S/T48G/T46U/T46S/T46G/T43U/T42U/T42S/T41S/T29G/T27G phones,
make sure the Wi-Fi USB dongle is properly connected to the USB port on the back of the phone.
Topics

Wi-Fi Configuration

Wireless Network IP Addressing Mode Configuration
IPv4 Wireless Network Configuration
IPv6 Wireless Network Configuration
Wi-Fi Configuration
The following table lists the parameters you can use to configure Wi-Fi.
Parameter static.wifi.function.enable
Description It enables or disables the Wi-Fi feature.
0-Disabled
Permitted
Values
1-Enabled
Default 1
Supported
T57W, T54W, T53W, T53, T53C, T48U, T48S, T48G, T46U, T46S, T46G, T43U, T42U, T42S, T41S,
Devices T29G, T27G, CP920, CP925, CP935W
Parameter static.network.redundancy.mode
Description It configures the network connection mode to be used preferentially.
0-If Wi-Fi mode is activated, the wired network is unavailable; Wi-Fi mode must be deactivated if you
want to use the wired network.
Permitted
1-Use wireless network preferentially.
Values
2-Use wired network preferentially.
Default 2
Supported
T57W, T54W, T53W, T53, T53C, T48U, T48S, T48G, T46U, T46S, T46G, T43U, T42U, T42S, T41S,
Devices T29G, T27G, CP920, CP925
Parameter static.network.redundancy.failback.timeout
It configures the time to wait (minutes) for the phone to switch to the preferentially used network.
Description
Note: It works only if "static.network.redundancy.mode" is not set to 0 and there are multiple networks
on the phone at the same time.
Integer from 0 to 1440
0-The phone will not switch as long as the current network is available.
Permitted
Values
1 to 1440–The phone will keep using the current network for the specified time after the preferentially
used network becomes available. If the preferentially used network is still available after the specified
time, the phone performs a network switch while the phone is not in use.
43
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg