Viewing Configurations Configured Via Different Provisioning Methods; Setting Up A Provisioning Server - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
0-Disabled
Permitted
Values
1-Enabled, the phone saves the entered PIN code and users do not need to enter again.
Default 1
Supported
T57W, T54W, T53W, T53, T53C, T48U, T46U, T43U, T42U, T48S, T46S, T42S, T41S, T33P, T33G,
T31P, T31G, T31, T30P, T30, T27G, CP920, CP925, CP935W
Devices

Viewing Configurations Configured via Different Provisioning Methods

On the web user interface, you can click the question mark "?" after each configuration to see its detailed inform-
ation. It is only applicable to
T57W/T54W/T53W/T53/T53C/T48U/T48S/T46U/T46S/T43U/T42S/T42U/T41S/T27G/CP920/CP925/CP935W
phones.
From the detailed information, you can do the following:
Check whether settings you make using a higher priority provisioning method override settings made using a
l
lower priority provisioning method.
Reset a configuration to factory setting.
l
See the default value of the desired configuration.
l
The table lists each parameter in the detailed information.
Parameter
Description
CFG Configuration
Valid Value
Configuration Source Values
(This appears only when the para-
meter "static.auto_pro-
vision.custom.protect" is set to 1.)

Setting Up a Provisioning Server

You can use a provisioning server to configure your phones. A provisioning server allows for flexibility in upgrading,
maintaining and configuring the phone. Boot files, configuration files, and resource files are normally located on this
server.
Topics
96
Description of this configuration item
The parameter in the configuration file
The permitted values
Not Applicable: the value is not changed via phone or
web user interface.
Web/Local:
(It appears only for a
Specific value: the value is changed via phone or web
non-static parameter.)
user interface. Click Reset to reset the value.
Not Applicable: the parameter is not changed in the con-
Config:
figuration files.
(It appears only for a
Specific value: the parameter is changed in the con-
non-static parameter.)
figuration files. Click Reset to reset the value.
Not Applicable: the parameter is not configured in any
Static: provisioning method.
(It appears only for a
Specific value: the value is configured in any pro-
static parameter)
visioning method. Click Reset to reset the value.
Default: Default value
Description