Digit Map For All Lines Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
Example:
"<9,:55>xx", after entering digit "9", secondary dial tone plays and you can complete the remaining two-
digit number.
Note: The secondary dial tone can be customized. For more information, refer to Tones.
The letter "A" indicates the account that is applied to the digit map. You can use A alone or a com-
bination of A and account ID (for example, <A1>).
Example:
"123A", the default account will be applied to the digit map.
A
"123<A2>", the second account will be applied to the digit map.
Note: It is not applicable to the digit map on a per-line basis. It is also not applicable to emergency num-
bers (phone_setting.phone_lock.emergency.number_rule).

Digit Map for All Lines Configuration

The following table lists the parameters you can use to configure the digit map for all lines.
Parameter dialplan.digitmap.enable
It enables or disables the digit map feature.
Description
Note: The value configured by the parameter "account.X.dialplan.digitmap.enable" takes precedence
over that configured by this parameter.
Permitted 0-Disabled
1-Enabled
Values
Default 0
Parameter dialplan.digitmap.string
It configures the digit map pattern used for the dial plan.
Example:
dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Description
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC
3435. It works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1
(Enabled). The value configured by the parameter "account.X.dialplan.digitmap.string" takes pre-
cedence over that configured by this parameter.
Permitted
String within 2048 characters
Values
Default [2-9]11 | 0T | 011xxx.T | [0-1][2-9]xx xxxxxxx | [2-9]xx xxxxxxx | [2-9]xxxT | **x.T | +x.T| 00x.T
Parameter dialplan.digitmap.interdigit_long_timer
It configures the time (in seconds) for the phone to wait before dialing an entered number if it matches
part of any string of the digit map.
If it is set to 0, the phone will not dial the entered number if only a partial match exists.
The value of this parameter should be greater than that configured by the parameter "dial-
Description
plan.digitmap.interdigit_short_timer".
For example:
dialplan.digitmap.string = 1xxT|xxxxx<T1>
dialplan.digitmap.interdigit_long_timer = 10
400
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg